[SOLVED] CS #include devices/pit.h

#include devices/pit.h
#include
#include
#include threads/interrupt.h
#include threads/io.h

/* Interface to 8254 Programmable Interrupt Timer (PIT).
Refer to [8254] for details. */

/* 8254 registers. */
#define PIT_PORT_CONTROL0x43/* Control port. */
#define PIT_PORT_COUNTER(CHANNEL) (0x40 + (CHANNEL))/* Counter port. */

/* PIT cycles per second. */
#define PIT_HZ 1193180

/* Configure the given CHANNEL in the PIT.In a PC, the PITs
three output channels are hooked up like this:

Channel 0 is connected to interrupt line 0, so that it can
be used as a periodic timer interrupt, as implemented in
Pintos in devices/timer.c.

Channel 1 is used for dynamic RAM refresh (in older PCs).
No good can come of messing with this.

Channel 2 is connected to the PC speaker, so that it can
be used to play a tone, as implemented in Pintos in
devices/speaker.c.

MODE specifies the form of output:

Mode 2 is a periodic pulse: the channels output is 1 for
most of the period, but drops to 0 briefly toward the end
of the period.This is useful for hooking up to an
interrupt controller to generate a periodic interrupt.

Mode 3 is a square wave: for the first half of the period
it is 1, for the second half it is 0.This is useful for
generating a tone on a speaker.

Other modes are less useful.

FREQUENCY is the number of periods per second, in Hz. */
void
pit_configure_channel (int channel, int mode, int frequency)
{
uint16_t count;
enum intr_level old_level;

ASSERT (channel == 0 || channel == 2);
ASSERT (mode == 2 || mode == 3);

/* Convert FREQUENCY to a PIT counter value.The PIT has a
clock that runs at PIT_HZ cycles per second.We must
translate FREQUENCY into a number of these cycles. */
if (frequency < 19){/* Frequency is too low: the quotient would overflow the 16-bit counter.Force it to 0, which the PIT treats as 65536, the highest possible count.This yields a 18.2 Hz timer, approximately. */count = 0;}else if (frequency > PIT_HZ)
{
/* Frequency is too high: the quotient would underflow to
0, which the PIT would interpret as 65536.A count of 1
is illegal in mode 2, so we force it to 2, which yields
a 596.590 kHz timer, approximately.(This timer rate is
probably too fast to be useful anyhow.) */
count = 2;
}
else
count = (PIT_HZ + frequency / 2) / frequency;

/* Configure the PIT mode and load its counters. */
old_level = intr_disable ();
outb (PIT_PORT_CONTROL, (channel << 6) | 0x30 | (mode << 1));outb (PIT_PORT_COUNTER (channel), count);outb (PIT_PORT_COUNTER (channel), count >> 8);
intr_set_level (old_level);
}