[SOLVED] CS计算机代考程序代写 Family Name ……………………………….. Given Name ………………………………… Student No. …………………………………. Signature ……………………………………

Family Name ……………………………….. Given Name ………………………………… Student No. …………………………………. Signature ……………………………………
THE UNIVERSITY OF NEW SOUTH WALES School of Electrical Engineering & Telecommunications MID-SESSION EXAMINATION
S1 2013
ELEC1112
Electrical Circuits
TIME ALLOWED:
TOTAL MARKS:
TOTAL NUMBER OF QUESTIONS:
55 minutes 40
5
THIS EXAM CONTRIBUTES 40%TO THE TOTAL COURSE ASSESSMENT
Reading Time: 5 minutes.
This paper contains 4 pages.
Candidates must ATTEMPT ALL questions.
Answer all questions in the answer booklet provided.
Marks for each question are indicated beside the question.
This paper MAY NOT be retained by the candidate.
Print your name, student ID and question number on the front page of each answer book. Authorised examination materials:
Candidates should use their own UNSW-approved electronic calculators.
This is a closed book examination.
Assumptions made in answering the questions should be stated explicitly.
All answers must be written in ink. Except where they are expressly required, pencils may only be used for drawing, sketching or graphical work.

QUESTION 1 [8 marks]
(i) (4 marks) For the circuit in Figure 1 below, calculate the equivalent resistance of the network at terminals a-b.
Figure 1.
(ii) (4 marks) For the circuit below in Figure 2,
a) Determine the current and voltage .
b) Determine the power absorbed or supplied by the resistors and the voltage sources. For each element, you should specify whether the power is absorbed or supplied.
Figure 2.
Page 2

QUESTION 2 [8 marks]
For the circuit shown below in Figure 3, assume ground is the reference node.
Use nodal analysis to write down enough equations to be able to solve for the voltages labelled , , and . (Note: You should NOT solve them)
Figure 3.
QUESTION 3 [8 marks]
For the circuit below in Figure 4, use the superposition principle to determine the current that would flow in the 12  resistor.
800V
40
A 60 5A 12
B
Figure 4.
Page 3

QUESTION 4 [8 marks]
For the circuit below in Figure 5, find the Thévenin equivalent circuit with respect to the terminals A,B.
Hint: You must find the Thévenin equivalent voltage, Vth, and resistance, Rth. 20V
20
QUESTION 5 [8 marks]
6A
60
10
Figure 5.
A
B
For the circuit below in Figure 6, the switch has been open for a long time before closing at time t = 0.
(i) (4 marks) Calculate the inductor current and capacitor voltage immediately after the switch closes.
(ii) (4 marks) Calculate the inductor current and capacitor voltage as
Figure 6.
END OF PAPER
Page 4