[Solved] CS39001 Assignment2-Verilog Design of Binary Adders

1. [Ripple Carry Binary Adder] Design (using Verilog), simulate, and synthesize for any target FPGA supported by your version of Vivado an 8-bit ripple carry adder. Your design should consist of a cascade of eight full adders. Write a testbench to simulate it. After logic synthesis, note its hardware requirement and critical path delay from the synthesis report. The interface of your design should be:

module ripple carry adder (input [7:0] a, input [7:0] b, input cin, output [7:0] sum,

output cout);. (5 marks)

2. [Hybrid Binary Adder] Design (using Verilog), simulate, and synthesize for any target FPGA supported by your version of Vivado, an 8-bit hybrid adder. Your design should consist of a cascade of two 4-bit carry lookahead adders. Write a testbench to simulate it. After logic synthesis, note its hardware requirement and critical path delay from the synthesis report. The interface of your design should be:

module hybrid adder (input [7:0] a, input [7:0] b, input cin, output [7:0] sum, output

cout);. (6 marks)

3. [Bit-serial Binary Adder] Design (using Verilog), simulate and synthesize for any target FPGA supported by your version of Vivado, a bit-serial adder. Write a testbench to simulate it. After logic synthesis, note its hardware requirement and critical path delay from the synthesis report. The input-side shift registers used in the datpath of your bit-serial adder should have parallel load capabilities such that the 8-bit operands can be loaded in each of them in one clock cycle. Come up with a proper interface of your design, which includes all input control signals and a clock signal. (7 marks)
4. Finally, submit a small 1-page report (in .pdf format) comparing the speed of operation and hardware requirements of the above three designs. This report should be inside the zipped folder you submit. (2 marks)